Thermalright Macho120 Rev.A Especificaciones descargar pdf (Pagina 6)

Installation Instructions:

Step 1:

Step 2:

Step 3:

Step 1 : Take out Macho cooler from the paper box.

Remove the 120mm Fan from the cooler by pulling the Fan Clips upwards in order to give room for ease

of installation. And leave the Fan Clips on the Heatsink Body. Do not remove them.Apply Anti-Vibration

Padding to 4 corners on the Heatsink Body.

Step 2 : Install the four screw pillars.

Take one M3L10 screw and put one washer for Intel around the screw pillar. Snap it through one of

holes around CPU socket from bottom towards top. Cap the screw pillar with the screw nut included and

then tighten up. Now repeat this installation for the other three screw pillars in a criss-cross pattern.

Step 3 : Place the Anchoring Mount on the Screw Nuts.

Use the four M3L6 screws to x the Anchoring Mount on to the Screw Nuts.

1 2 3 4 5 6 7 8 9 10 11 ... 32 33

Sin comentarios

Thermalright Macho120 Rev.A Especificaciones Pagina 6